Search results for "Ion yield"
showing 10 items of 11 documents
Fibre extraction from oleaginous flax for technical textile applications: influence of pre-processing parameters on fibre extraction yield, size dist…
2017
International audience; Cultivated primarily for its seeds, oleaginous flax could also be valued for the different fractions that can be extracted from the straw. However, as the straws are not harvested with the same technique and care than for the textile flax, the classical scutching technique cannot be used. As a consequence, an “all fibre” device was used to perform the separation of the different constituents of the oleaginous flax straws. The different fractions were quantified for two retting levels and for two degrees of rewetting of the stems. The physical and mechanical properties of fibres were then evaluated. It appears that the relative amount of fibres extracted from oleagino…
Synthesis and structure of a new organometallic polyoxomolybdate,
2004
Abstract Acidic aqueous solutions of the [Cp*MoO2(H2O)x]+ ion yield single crystals of the novel organometallic polyoxomolybdate Cp 2 ∗ Mo 6 O 17 via a slow protonolysis of the Mo–Cp* bond. This compound has subsequently been obtained selectively and in good yields from the combination of Cp 2 ∗ Mo 2 O 5 and four equivalents of MoO 4 2 - under acidic conditions. The X-ray structure of Cp 2 ∗ Mo 6 O 17 is analogous to other hexanuclear polyoxometallate ions but is the most distorted so far reported according to the continuous symmetry measure, the inner (μ6-O)Mo6 core featuring a large displacement of the central oxygen atom toward the organometallic moieties and away from the inorganic ones.
Energy level determination in bulk heterojunction systems using photoemission yield spectroscopy: case of P3HT:PCBM
2018
Financial support provided by Scientific Research Project for Students and Young Researchers Nr. SJZ2015/20 realized at the Institute of Solid State Physics, University of Latvia, is greatly acknowledged. This work has been supported by the Latvian State Research Program on Multifunctional Materials IMIS2. Jennifer Mann from Physical Electronics is greatly acknowledged for providing UPS data.
Biogenic iron-silver nanoparticles inhibit bacterial biofilm formation due to Ag+ release as determined by a novel phycoerythrin-based assay
2020
Silver nanoparticles (Ag-NPs) can be considered as a cost-effective alternative to antibiotics. In the presence of Fe(III)-citrate and Ag+, Klebsiella oxytoca DSM 29614 produces biogenic Ag-NPs embedded in its peculiar exopolysaccharide (EPS). K. oxytoca DSM 29614 was cultivated in a defined growth medium–containing citrate (as sole carbon source) and supplemented with Ag+ and either low or high Fe(III) concentration. As inferred from elemental analysis, transmission and scanning electron microscopy, Fourier transform infrared spectrometry and dynamic light scattering, Ag-EPS NPs were produced in both conditions and contained also Fe. The production yield of high-Fe/Ag-EPS NPs was 12 times …
Production of Sn and Sb isotopes in high-energy neutron induced fission of natU
2018
The first systematic measurement of neutron-induced fission yields has been performed at the upgraded IGISOL-4 facility at the University of Jyväskylä, Finland. The fission products from high-energy neutron-induced fission of nat U were stopped in a gas cell filled with helium buffer gas, and were online separated with a dipole magnet. The isobars, with masses in the range A = 128-133 , were transported to a tape-implantation station and identified using γ -spectroscopy. We report here the relative cumulative isotopic yields of tin (Z = 50) and the relative independent isotopic yields of antimony (Z = 51). Isomeric yield ratios were also obtained for five nuclides. The yields of tin show a …
Resonant laser ionization of polonium at rilis-isolde for the study of ground- and isomer-state properties
2008
Three new ionization schemes for polonium have been tested with the resonant ionization laser ion source (RILIS) during the on-line production of 196Po in a UCx target at ISOLDE. The saturation of the atomic transitions has been observed and the yields of the isotope chain 193–198,200,202,204Po have been measured. This development provides the necessary groundwork for performing in-source resonant ionization spectroscopy on the neutron-deficient polonium isotopes (Z = 84). ispartof: Nuclear Instruments & Methods in Physics Research B vol:266 issue:19 pages:4403-4406 ispartof: location:FRANCE, Deauville status: published
The upgraded ISOLDE yield database – A new tool to predict beam intensities
2020
At the CERN-ISOLDE facility a variety of radioactive ion beams are available to users of the facility. The number of extractable isotopes estimated from yield database data exceeds 1000 and is still increasing. Due to high demand and scarcity of available beam time, precise experiment planning is required. The yield database stores information about radioactive beam yields and the combination of target material and ion source needed to extract a certain beam along with their respective operating conditions. It allows to investigate the feasibility of an experiment and the estimation of required beamtime. With the increasing demand for ever more exotic beams, needs arise to extend the functi…
Electron Emission of Pt: Experimental Study and Comparison With Models in the Multipactor Energy Range
2016
Experimental data of secondary emission yield (SEY) and electron emission spectra of Pt under electron irradiation for normal incidence and primary energies lower than 1 keV are presented. Several relevant magnitudes, as total SEY, elastic backscattering probability, secondary emission spectrum, and backscattering coefficient, are given for different primary energies. These magnitudes are compared with theoretical or semiempirical formulas commonly used in the related literature.
The Role of Combined ICRF and NBI Heating in JET Hybrid Plasmas in Quest for High D-T Fusion Yield
2017
Combined ICRF and NBI heating played a key role in achieving the world-record fusion yield in the first deuterium-tritium campaign at the JET tokamak in 1997. The current plans for JET include new experiments with deuterium-tritium (D-T) plasmas with more ITER-like conditions given the recently installed ITER-like wall (ILW). In the 2015-2016 campaigns, significant efforts have been devoted to the development of high-performance plasma scenarios compatible with ILW in preparation of the forthcoming D-T campaign. Good progress was made in both the inductive (baseline) and the hybrid scenario: a new record JET ILW fusion yield with a significantly extended duration of the high-performance pha…
Fission yield studies with SPIG-equipped IGISOL : a novel method for nuclear data measurements
2010
This thesis work consists of two sections. In the first section, the development of a so-called Laser Ion Source Trap (LIST) device is described. The LIST device is based on a double SPIG (SextuPole Ion Guide) system, providing the possibility to improve the elemental selectivity of the IGISOL method via highly discriminative laser ionization occurring outside the ion guide. The improved selectivity enables the production of isotopically pure beams. The double SPIG can be used without laser ionization and replaces the conventional skimmer electrode. In this work, the SPIG is compared to the skimmer and is shown to remarkably improve both the efficiency and beam quality of the IGISOL facilit…